Dimond Hibond composite flooring

Dimond Hibond Composite Flooring

Hibond Composite Flooring is manufactured in Auckland.

If this product is not suitable for your project... Click here to find product options suitable for your requirements.

Dimond HiBond Flooring

Hibond is a composite steel flooring system that has been successfully used in a wide variety of commercial and residential applications for over thirty years. It is a proven performer in the three key areas of strength, reliability and economy. Hibond is a versatile, lightweight system that delivers rapid and cost-effective installation saving on construction time. 

Dimond now offer two Hibond flooring profiles; the tried and true Hibond 55, and all new Hibond 80 enabling longer spans, and new possibilities, for more information contact Mike Klemick on 027 595 3076 or michaelkl@dimond.co.nz

Scope of Use

Dimond Flooring Systems use a roll-formed profiled galvanised steel sheet as a component in reinforced concrete floor systems. The sheet provides both permanent formwork and positive tensile reinforcement in one way reinforced concrete slab construction over concrete block walls, poured concrete beams, steel beams or timber beams, which are subject to environmental limitations referenced to the appropriate grade of material selected. 

It is critical to product performance that the loads applied, spans, formwork material thickness and overall slab thickness are designed within the appropriate Limit State Loads and limitations published in this manual. Before commencing a project using a Dimond Flooring System, the user must refer to the information within this manual and all sections as appropriate, ensuring relevant information is available to the end user. Failure to observe this information may result in a significant reduction in product performance. Dimond accepts no liability whatsoever for products which are used otherwise than in accordance with these recommendations.

The information contained within Flooring Systems is only applicable to Dimond Flooring Systems – it cannot be assumed to apply to similar products from other manufacturers.

Use outside the stated Guidelines

If the need arises to use the Dimond Flooring System outside the limitations and procedures given in this manual or if there exists any doubt on product handling or use, written approval should be obtained from Dimond for the specific project, before the project is commenced.

Load Span Tables

DHS Load Span tables for Single, End and internal spans can be found here.

Find An Installer

Share to social media